Guaranteed High Marks with Updated & Real JN0-649 Dumps pdf Free Updates [Q27-Q47]

NO.27 You are asked to deploy 802.1X on your EX Series switches. You need to ensure authenticated devices continue to have access to the network even if the authentication server fails.
Which action meets this configuration objective?

NO.28 You are designing a multicast topology to support IPv4 IPTV broadcasts in your organization. The design should support multiple multicast senders with overlapping group addresses while preventing interference between them. Client devices currently do not support IGMPv3.
Which approach would fulfill these requirements?

NO.29 Referring to the exhibit, which two statements are true? (Choose two)

NO.30 You are configuring MVRP for automatic VLAN registration. Which two statements are true?
(Choose two.)

NO.31 You want to provide Layer 2 connectivity between campus sites using Ethernet switches through a metro Ethernet service provider who is using Q-in-Q tagging on their network.
Referring to the exhibit, what are two design considerations in this environment? (Choose two.)

NO.32 Which two statements are correct regarding the behavior shown in the exhibit? (Choose two.)

NO.33 Click the Exhibit button.

Referring to the exhibit, you must advertise the 100.0.0.0/16 routes from AS1 to AS2, but R2 is not advertising any BGP routes to R5.
Why is this happening in this scenario?

NO.34 When redistributing IGP routes into BGP. what information .s used by default on Junos platforms to determine the BGP route’s MED attribute value?

NO.35 Your EX Series switch has IP telephones and computers connected to a single switch port. You are considering implementing the voice VLAN feature to help with this setup. In this scenario, which two statements are correct? (Choose two.)

NO.36 You are enabling MSTP in your Layer 2 network to prevent loops. In this scenario, which three parameters must match on all switches in the network? (Choose three. )

NO.37 Click the Exhibit.

You have a workstation and VoIP phone connected to port ge-0/0/1 on an access switch.
Referring to the configuration shown in the exhibit, which statement is true?

NO.38 Which two statements are correct about the deployment of EVPN-VXLAN on QFX Series devices? (Choose two.)

NO.39 Click the Exhibit.


The ping command shows that connectivity of the 200.0.1/24 network to the 200.0.200.0/24 network exists. You notice that all the ping test results from various devices on 200.0.1.0/24 follow the same path even through equal cost paths exist to the 200.0.200.0/24 network.
Referring to the exhibit, what is happening?

NO.40 You notice a mass withdrawal of routes for some of the network hosts. You determine that the link on the ESI interface is down.
Which route type is used in this scenario?

NO.41 Which two multicast listener registration protocols are supported in the Junos operating system? (Choose two.)

NO.42 You are implementing 802.1x authentication in your Layer 2 network. Each user will have a computer and a phone and you must ensure that both device are authenticated individually. In this scenario, which supplicant mode should be used?

NO.43 You have deployed the access control configuration to the distribution switch.


Referring to the exhibit, which statement is true?

NO.44 You are asked to establish full connectivity between all devices in the BGP network. Referring to the exhibit, which two configuration changes will allow BGP route advertisements? (Choose two.)

NO.45 Click the Exhibit.

Switch 4 is rebooted as shown in the exhibit.
Which statement is correct in this scenario?

NO.46 You are deploying new Juniper EX Series switches in a network that currently is using Cisco’s Per- VLAN spanning tree plus (PVST+) and you must provide compatibility with this environment.
Which spanning tree protocol do you deploy in this scenario?

NO.47 You recently implemented the configurations shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communication with the appropriate community devices connected to AS-2.
What must be to allow these community devices to communicate?