Steps Necessary To Pass The H31-311_V2.5 Exam from Training Expert PrepAwayETE [Q45-Q61]

Q45. For MSPs, you need to set the MSP protocol ID for each NE. To ensure that each ID is unique, it is recommended to set the MSP protocol ID to the value that is compatible with the network element ID.

Q46. Which of the following logical function modules is used to generate exhaust R-LOS alerts?

Q47. Some SNCP protection inversion conditions are default, such as AU-AIS and TU-AIS. Other conditions are optional, such as HP-TIM and HP-SLM. Optional conditions can be flexibly set according to the level of the costume.

Q48. QinQ technology can be used when multiple users need to share the same VCTRUK and use the same VLAN ID.

Q49. Which of the following statements about the OTM-n .m and OTMnr .m for OTN are incorrect?

Q50. Which of the following logic function blocks are involved in processing clock signals? (Multiple choice).

Q51. Which of the following is the meaning of “L” in the optical module parameter “L-64.2”

Q52. Which of the following is the multiplexing method of SDH?

Q53. The backplane has two 48V power cords, and each board gets two -48V power supplies from the backplane. After combining the power supply via diodes, the various voltages required for each component are obtained by means of a DC/DC power module and a linear mane swap.

Q54. Which of the following device domains can be managed by U2000? (Multiple choice).

Q55. Which of the following are the service board types for MSTP devices? (Multiple choice).

Q56. Which of the following statements regarding multiplexing partial remote error indication (MS-REI) is correct?
(1) B2 bytes indicate the transmission channel.
(2) The M1 byte represents the transmission channel
(3) THE MS-REl is sent from the receiver to the source.
(4) MS-REI is transmitted from the source to the receiver.
(5) Indicates the number of bit errors detected by the receiver after receiving the MS signal.

Q57. The last 256 columns in the OTN frame structure are the FEC regions for forward error correction.

Q58. When the fiber between node A and node B is disconnected, the RU on node B detects OTS_LOS alarm and will OTS_BDI The ru of the alert inserted into node A of node A forces reports OTS BDI alarms. The board reports och_SSF alarm on the downstream C node.

Q59. When the bridge uses ivl learning mode, an entry in the MAC address table is created based on the source MAC address and source port of the teach frame. This entry applies to all VLANs

Q60. Which of the following are device-level protection schemes for SDH products? (Multiple choice).

Q61. K1 and K2 bytes can send APS switching signaling or indicate that the multiplexed segment signal is invalid.