[Jan-2023] NACE-CIP2-001 Exam Dumps, NACE-CIP2-001 Practice Test Questions [Q15-Q38]

NO.15 Ideally, documentation requirements should be defined:

NO.16 Inspection and Test plans are developed by referencing:

NO.17 When observing fabrication defects the NACE Inspector should:

NO.18 You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

NO.19 When completing the Final Inspection report the Inspector should write the report using:

NO.20 You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:

NO.21 When using a destructive Paint Inspection Gauge the NACE inspector must:

NO.22 Examples of non-ferrous metals include
Select All that Apply:

NO.23 When environmental enclosures are being used an inspector needs to be concerned about:

NO.24 Which product, is used in conjunction with other coatings such as FBE when the lines run through wetlands or a body of water?

NO.25 When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

NO.26 NACE Level 2 Inspectors have been authorized to perform:

NO.27 You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and you are asked to take DIY Film Thickness readings.
Your FIRST preferred course of action is to:

NO.28 Corrosion is the reverse process of

NO.29 You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

NO.30 Inspector reports should always be copied to:

NO.31 In the event of a conflict between the Product Data Sheet and the Specification:

NO.32 The main reason dehumidification is used during coating operations is to

NO.33 You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

NO.34 An Inspection and Test Plan is required when:

NO.35 When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:

NO.36 Surface preparation of concrete is performed using:

NO.37 When conducting inspections the Inspector should follow which standards:

NO.38 Which concrete smoothing technique involves scrubbing a mixture of cement mortar over the concrete surface using ai cement sack, gunny sack, or sponge rubber float?