[Q14-Q29] Get Prepared for Your JN0-250 Exam With Actual Juniper Study Guide!

NO.14 You have designed a WLAN to satisfy primary coverage, secondary coverage, and capacity requirements. However, you still do not have enough BLE radios to satisfy your location requirements. You want to fill the gaps with a low cost, BLE-only device.
Which Mist device will satisfy this requirement?

NO.15 A Mist access point is booting up, and will soon receive a channel assignment from the Mist Cloud. The channel assigned by the cloud is a DFS channel.
In this scenario, what must the AP do before broadcasting an SSID on the channel?

NO.16 Marvis requires which subscription?

NO.17 Which 802.11 amendment added OFDMA?

NO.18 You are designing a wireless network that requires smooth roaming performance and redundant coverage from at least two access points at every location.
What ensures that both of these functional requirements are satisfied?

NO.19 Which two statements about the Mist UI are true? (Choose two.)

NO.20 You are configuring your Mist network and you want to separate certain users into their own networks and VLANs. You are concerned about the network’s utilization and want to make sure that only a single SSID is sending beacons.
In this scenario, which feature would accomplish this behavior?

NO.21 What would cause 5 GHz interference?

NO.22 You have discovered an access point that is not connected to the corporate network but it broadcasts the corporation’s SSID.
In this scenario, what is this type of access point called?

NO.23 You are troubleshooting a signal strength issue when you notice that the signal strength changes from -70 to -73 dBm as you move from one room to another.
In this scenario, what is happening?

NO.24 Which organization is responsible for creating the 802.11 standard?

NO.25 Under ideal conditions, which frequency band will have the farthest usable range?

NO.26 Referring to the exhibit, what do you determine about the site’s Time to Connect SLE metric?

NO.27 A microwave oven would be classified as which type of interference?

NO.28 When would be the earliest opportunity to configure an access point (AP)?

NO.29 You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting “insufficient power.” The APs are connected to an 802. 3at-capable switch.
In this scenario, what would be the cause of the error?