Get Feb-2023 Dumps to Pass your 300-410 Exam with 100% Real Questions and Answers [Q16-Q36]

QUESTION 16
Refer to the exhibit.

Which action resolves the adjacency issue?

QUESTION 17
Refer to the exhibit.

Which command must be configured to make VRF CCNP work?

QUESTION 18
An engineer configured the wrong default gateway for the Cisco DNA center enterprise interface during the install.
Which command must the engineer run to correct the configuration?

QUESTION 19
Refer to the exhibit.

An engineer must establish a point-to-point GRE VPN between R1 and the remote site. Which configuration accomplishes the task for the remote site?

QUESTION 20
Drag and drop the actions from the left into the correct order on the right to configure a policy to avoid following packet forwarding based on the normal routing path.

QUESTION 21
Refer to Exhibit:


AS 111 wanted to use AS 200 as the preferred path for 172.20.5.0/24 and AS 100 as the backup. After the configuration, AS 100 is not used for any other routes. Whichconfiguration resolves the issue?

QUESTION 22
Which statement about route distinguishers in an MPLS network is true?

QUESTION 23
Refer to the exhibit.

Which interface configuration must be configured on the HUB router to enable MVPN with mGRE mode?

QUESTION 24
When provisioning a device in Cisco DNA Center, the engineer sees the error message “Cannot select the device. Not compatible with template”.
What is the reason for the error?

QUESTION 25
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.

QUESTION 26
Refer to the exhibits.

When DMVPN is configured, which configuration allows spoke-to-spoke communication using loopback as tunnel source?

QUESTION 27
Drag and drop the MPLS concepts from the left onto the descriptions on the right.

QUESTION 28
Refer to the exhibit.

During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?

QUESTION 29
Refer to the exhibits. The output of the trace route from R5 shows a loop in the network.
Which configuration prevents this loop?

QUESTION 30
Refer to the exhibit.

An engineer cannot copy the IOS.bin
Which action resolves the issue?

QUESTION 31
Refer to the exhibit.

Which interface configuration must be configured on the space A route enable a dynamic DMVPN tunnel with the spoke B router?
A)

B)

C)

D)

QUESTION 32
Drag and drop the operations from the left onto the locations where the operations are performed on the right.

QUESTION 33
Refer to the exhibit.

An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen. What is the reason for this?

QUESTION 34
An engineer configured SNMP notifications sent to the management server using authentication and encrypting data with DES. An error in the response PDU is received as “UNKNOWNUSERNAME. WRONGDIGEST”. Which action resolves the issue?

QUESTION 35
A customer is running an mGRE DMVPN tunnel over WAN infrastructure between hub and spoke sites. The existing configuration allows NHRP to add spoke routers automatically to the multicast NHRP mappings. The customer is migrated the network from IPv4 to the IPv6 addressing scheme for those spokes’ routers that support IPv6 and can run DMVPN tunnel over the IPv6 network. Which configuration must be applied to support IPv4 and IPv6 DMVPN tunnel on spoke routers?

QUESTION 36
Drag and drop the operations from the left onto the locations where the operations are performed on the right.