[Q59-Q74] 2024 Updates For the Latest 4A0-113 Free Exam Study Guide!

QUESTION 59
Which type of OSPF LSA has the following characteristics: It is flooded only within the area it originates from and can be originated by any OSPF router within the area (including non-DR routers).

QUESTION 60
Click the exhibit button.

The following command sequence is executed on router R2:
A: R2# configure router ospf router-id 10.10.10.99
A: R2# configure router router-id 10.10.10.66
On router R1, what router ID appears for router R2 directly after these commands are executed?

QUESTION 61
From the list below select the statements that describe the behavior of link state information aging. (Choose 2)

QUESTION 62
In an OSPF environment, what must a router receive after it sends out an update?

QUESTION 63
In an IP datagram, which of the following fields identifies the receiving application?

QUESTION 64
What are the ways the RID can be created on an Nokia 7750 SR router? (Choose three)

QUESTION 65
Refer to the exhibit.

Assume that OSPFv3 is properly configured on all routers and that R4 advertises its system prefix into Area 0. Which of the following statements best describes how R5 learns R4’s IPv6 system prefix?

QUESTION 66
What must be configured on the Nokia 7750 SR for RIP to advertise locally attached links?

QUESTION 67
What is the protocol number for OSPF in the IP header?

QUESTION 68
Click the exhibit button.

Which of the following would correctly configure routers R2, R3, and R4?

QUESTION 69
The Nokia 7750 SR supports which two of the OSPF area types below?

QUESTION 70
Click the exhibit button.

In the topology shown, router R1 is an ASBR configured to export external routes to OSPF. Assuming that there are no stub networks, which of the following statements regarding type 4 LSA generation is true?

QUESTION 71
A static route is created using the command “static-route 2.3.4.0/24 next-hop 1.2.3.4”. What is the correct traceroute command to test this static route on an Nokia 7750 SR?

QUESTION 72
Which of the following statements describe the major features of OSPF? Choose two answers.

QUESTION 73
An interface is configured on a router for OSPF but the command “show router ospf neighbor” does not show any neighbors. Which of the following is NOT a possible cause?

QUESTION 74
Click the exhibit button.

In the topology shown, router R1 is an ASBR configured to export external routes to OSPF. Assuming that there are no stub networks, which of the following statements regarding Type 4 LSA generation is true?