Reliable NACE-CIP1-001 Dumps Questions Available as Web-Based Practice Test Engine [Q45-Q59]

QUESTION 45
Corrosion generally occurs at which of the following sites:

QUESTION 46
What is used to determine compressed air cleanliness?

QUESTION 47
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

QUESTION 48
Prior to using Inspection Tools the inspector must:

QUESTION 49
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

QUESTION 50
When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

QUESTION 51
Stripe coats are generally applied to:

QUESTION 52
What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

QUESTION 53
Whenever dissimilar metals must join, the most common practice is to

QUESTION 54
The Inspector should record the serial numbers of inspection instruments:

QUESTION 55
Owners hire NACE Inspectors’ with the expectation that:

QUESTION 56
Daily reports are important because:
Select All That Apply

QUESTION 57
The Inspector’s Log Book is generally:

QUESTION 58
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

QUESTION 59
SSPC SP 1 identifies the use of: